Many materials age and wear quickly; bronze, brass, rubber and steel are not always the most optimal material for a given application which affects efficiency and production. Using Redco™ Plastic products such as Redco™ Polyurethane and Redco™ UHMW will improve performance with little initial cost and long term benefits, as well as reduce wear and noise, and minimize product damage.
Bearings, conveyor liners, chain channel, electrical components, o-ring retainers, bushings, gears, saw guides, safety enclosures and windshields, sprockets, sleaner cones, roll coverings, sorter hooks, wear plates, wear slides, carry-over wheels, chip screens, flights, gaskets, lantern rings, nozzles, channel, liners, seals, suction box covers, rollers, etc.
Redco™ Synsteel Chip Screens
TOP SCREENS
Usually done in 2 or 3 sections depending on the sizes: should be supported 18-24″ to allow for sag – if possible, 16″ centers would be ideal.
FINE SCREENS
Usually done in the same manner only with smaller holes – 3/8″ dia. & bigger, some 5/16″ done. The problem here is the thickness of 1/4″ material causing a plug up in the screen. This can be relieved by counter sinking the back of the holes.
Redco™ UHMW Crimping Pads
Redco™ UHMW Suction Box Cover
Redco™ UHMW Lined Conveyor with Flights
Redco™ UHMW Corner Protectors
Redco™ Dual Hardness Polyurethane Feed Wheels