CALL 833 381 1195
Select Page

Out of the many parts and plastic profiles requested of Redwood Plastics and Rubber, plastic angle keeps coming up. This is typically plastic bent at a 90 degree angle halfway. This is primarily used for protection of a surface or object if machined out of UHMW or nylon plastic. However, much stronger (more rigid) fiberglass reinforced plastic (FRP) angle is available and stocked by our supplier. A common example of a FRP angle application would be to bolt it in on the edge of a platform at a train station. FRP angle is available in a variety of widths and thicknesses with 1/4″ and 3/8″ thick being the most common. It is available in all three primary EXTREN resin types (general purpose polyester, fire-retardant polyester, and vinyl ester). These angle profiles are more expensive than steel or aluminum angle; however, for certain applications such as those that demand electric or radio non-conductivity, plastic angle may be your only choice.

To get a quote on an angle profile is easy. Firstly, we need to know the width of each side of the angle, they are not always the same! We then need to know both the thickness and the material required. If you need assistance selecting a material, just ask, but me sure to be ready to answer questions about your application such as what the angle is doing, if there is any chemical or high heat exposure, etc. Angle profiles of all plastic types are typically sold by the 10 foot length; however, there are cases where we can supply shorter or longer profiles.

For a quote on your plastic angle needs, please contact us today.